CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: New Setup

Posted by Art
on 2002-11-14 14:55:21 UTC
> the L297/L298 and using a PIC uController to control them and take
> input from digitizing probes etc (it'd be a serial device with an
> error control protocol, and the PIC would take care of ramping
> up/down speed and providing steps instead of the PC, so I could
write
> Windows driver software and performance would not be an issue)
>
I hope this is a hobby, the above paragraph looks like a 2-3 year
learning curve. Sounds kinda like me a few years ago. (If only I knew then
what I know now...)
:)
Art
www.artofcnc.ca

Discussion Thread

abbylynx 2002-11-14 07:35:46 UTC New Setup caudlet 2002-11-14 08:20:19 UTC Re: New Setup Art 2002-11-14 14:55:21 UTC Re: [CAD_CAM_EDM_DRO] Re: New Setup James Owens 2002-11-14 16:47:37 UTC Re: [CAD_CAM_EDM_DRO] New Setup echnidna 2002-11-14 17:34:07 UTC Re: New Setup Alan Marconett KM6VV 2002-11-14 17:42:53 UTC Re: [CAD_CAM_EDM_DRO] New Setup JJ 2002-11-15 04:32:15 UTC RE: [CAD_CAM_EDM_DRO] New Setup abbylynx 2002-11-15 10:32:59 UTC Re: New Setup