Re: [CAD_CAM_EDM_DRO] New Setup
Posted by
Alan Marconett KM6VV
on 2002-11-14 17:42:53 UTC
Terry,
But I LIKE to write controller programs, design digitizer probes, and
even driver now and then!
Alan KM6VV
James Owens wrote:
up a job on the machine.
But I LIKE to write controller programs, design digitizer probes, and
even driver now and then!
Alan KM6VV
James Owens wrote:
>An edge finder, either electronic or manual, will take care of setting
> Hi,
>
> I have a question for you, why do you want to reinvent the wheel with a toy machine? This is a rhetorical question and not meant to cause offence to you or other Sherline users.
><SNIP>
up a job on the machine.
>
> There is no need to write drivers, design driver boards or developing digitising probes............... unless you think you can do better.
>
> Regards,
>
> Terry
Discussion Thread
abbylynx
2002-11-14 07:35:46 UTC
New Setup
caudlet
2002-11-14 08:20:19 UTC
Re: New Setup
Art
2002-11-14 14:55:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: New Setup
James Owens
2002-11-14 16:47:37 UTC
Re: [CAD_CAM_EDM_DRO] New Setup
echnidna
2002-11-14 17:34:07 UTC
Re: New Setup
Alan Marconett KM6VV
2002-11-14 17:42:53 UTC
Re: [CAD_CAM_EDM_DRO] New Setup
JJ
2002-11-15 04:32:15 UTC
RE: [CAD_CAM_EDM_DRO] New Setup
abbylynx
2002-11-15 10:32:59 UTC
Re: New Setup