Re: Leadscrew Error
Posted by
edward c heil jr
on 2002-11-18 15:01:00 UTC
yes i use turbocnc and ver 4 is going to have this in the future
check out the turbocnc yahoo group its only $20 its a great program
with threading(reads spindle encoder for rpm)
check out the turbocnc yahoo group its only $20 its a great program
with threading(reads spindle encoder for rpm)
--- In CAD_CAM_EDM_DRO@y..., C.S. Mo <cs@v...> wrote:
> So I've been ruminating over converting my mill/drill to
ballscrews.. As
> has been discussed recently, there's a whole lot of quality levels
out
> there... On some high end machines it is possible to map out the
> leadscrew error - is there any way to do this with EMC or other
> "inexpensive" software? The advantage would be that you could,
> theoretically, use relatively inexpensive leadscrews.
>
> --C.S.
Discussion Thread
C.S. Mo
2002-11-18 14:28:09 UTC
Leadscrew Error
edward c heil jr
2002-11-18 15:01:00 UTC
Re: Leadscrew Error
Les Watts
2002-11-18 16:59:28 UTC
Re: [CAD_CAM_EDM_DRO] Leadscrew Error
Jon Elson
2002-11-18 21:06:41 UTC
Re: [CAD_CAM_EDM_DRO] Leadscrew Error
torsten98001
2002-11-19 13:29:09 UTC
Re: Leadscrew Error