Re: DC Brushless Motors and Drives
Posted by
deanc500
on 2002-11-29 09:41:41 UTC
Rutex has a brushless drive that accepts step and dir inputs.
www.rutex.com
Here is a clip from thier site:
R992 Servo motor drive - brush-less
RT990A/RT992 based servo drive. Up to 100 Volts 12 Amps / phase
single servo drive for brush-less DC permanent magnet motor with
feedback from encoders. Delivery 2-4 weeks ARO. $199
Dean
www.rutex.com
Here is a clip from thier site:
R992 Servo motor drive - brush-less
RT990A/RT992 based servo drive. Up to 100 Volts 12 Amps / phase
single servo drive for brush-less DC permanent magnet motor with
feedback from encoders. Delivery 2-4 weeks ARO. $199
Dean
--- In CAD_CAM_EDM_DRO@y..., "natchamp_87" <mark@h...> wrote:
> I have an opportunity to buy some very good DC brushless servo motors
> for my Bridgeport retrofit project. However, the motors will be
> little more than paper weights unless I have drives and a
> controller. Since Gecko's drives arn't anywhere on the horizon, is
> there any other cost effective solutions out there for brusless
> drives and controllers? I need to make a decision promptly, so any
> feedback is greatly appreciated.
> Mark
Discussion Thread
natchamp_87
2002-11-29 09:25:10 UTC
DC Brushless Motors and Drives
Jon Elson
2002-11-29 09:34:39 UTC
Re: [CAD_CAM_EDM_DRO] DC Brushless Motors and Drives
deanc500
2002-11-29 09:41:41 UTC
Re: DC Brushless Motors and Drives
Nicolas Benezan
2002-12-04 11:49:54 UTC
Re: [CAD_CAM_EDM_DRO] DC Brushless Motors and Drives
Jon Elson
2002-12-04 21:01:27 UTC
Re: [CAD_CAM_EDM_DRO] DC Brushless Motors and Drives
jeffalanp
2002-12-04 23:19:27 UTC
Re: DC Brushless Motors and Drives