Re: [CAD_CAM_EDM_DRO] Torroid Question

Thanks for the Tips guys.... That low amperage stuff just does not seem
right. I hope to locate the real paper work on these. Hopefully they
will have better looking numbers. I thought that when I bought them they
"claimed" 9 amps on the 44volt legs, and 4,5 amps on the 88v side...........

I think this thing is wound as shown below:

___ __________________________
| | | |
3 ||| 3 | |
3 ||| 3 44v |
3 ||| | _____________|___ |
3 ||| ____________/ |
3 ||| | | |
3 ||| 3 | |
3 ||| 3 44v 88v
___| | | |
__________________________

(I should frame that for the amount of time it took even After swiping the bulk of it from Bills message ! Thanks Bill !)

I wonder what you would use such a heavy and large transformer for if it only put out less than 1/2 an amp ?? Sounds like a waste of copper to me !

If I can get some bigger numbers, maybe I can use these, otherwise they are starting to look like landfill material. (Ok, recycleable material.....) Maybe they are 2000VA !??

Thanks,

Chris L