Re: [CAD_CAM_EDM_DRO] Surface Grinder conversion
Posted by
James Owens
on 2002-12-06 18:47:12 UTC
I also have an old tool and cutter grinder that I was thinking of CNCing once the mill is finished. I was thinking about using steppers/drivers and then a PIC based project to do the maths and move the axis's.
I didn't want to use a PC and CAM software because of space.
Regards,
Terry
I have a small, hand operated surface grinder (about 9"x5" travel).
It's not very exciting taking off metal operating it by hand :-)
Has anyone done a CNC conversion of one? Are there pitfalls/problems to
watch out for?
G-Code wouldn't seem to be needed. I was thinking of using a small single
board computer to drive the three axis via Gecko drives. I'm thinking of
simple functions like "grind this X/Y area to a depth of Z in steps of
Delta" ....
Cheers,
Chuck Hackett
"Good judgment comes from experience, experience comes from bad judgment"
7.5" gauge Union Pacific Northern (4-8-4) 844
Railroad: Camp Creek Railroaders, Waverly, Nebraska, USA (3000', 7.5")
Home: Elkhorn, Nebraska (just west of Omaha)
[Non-text portions of this message have been removed]
I didn't want to use a PC and CAM software because of space.
Regards,
Terry
I have a small, hand operated surface grinder (about 9"x5" travel).
It's not very exciting taking off metal operating it by hand :-)
Has anyone done a CNC conversion of one? Are there pitfalls/problems to
watch out for?
G-Code wouldn't seem to be needed. I was thinking of using a small single
board computer to drive the three axis via Gecko drives. I'm thinking of
simple functions like "grind this X/Y area to a depth of Z in steps of
Delta" ....
Cheers,
Chuck Hackett
"Good judgment comes from experience, experience comes from bad judgment"
7.5" gauge Union Pacific Northern (4-8-4) 844
Railroad: Camp Creek Railroaders, Waverly, Nebraska, USA (3000', 7.5")
Home: Elkhorn, Nebraska (just west of Omaha)
[Non-text portions of this message have been removed]
Discussion Thread
Egroupscdh (E-mail)
2002-12-05 14:29:39 UTC
Surface Grinder conversion
James Owens
2002-12-06 18:47:12 UTC
Re: [CAD_CAM_EDM_DRO] Surface Grinder conversion