Re: Re: Driver / Controller

Jim

Does Dolphin do CNC motion control along with all of it's other
capabilities?

Ray

>    From: "James Cullins" <jcullins@...>
> Subject: Re: Driver / Controller
>
> I don't see Dolphin.
> Jim
> ----- Original Message -----
> From: "Matt Shaver" <mshaver@...>
> To: <CAD_CAM_EDM_DRO@yahoogroups.com>
> Sent: Monday, December 09, 2002 12:07 AM
> Subject: Re: [CAD_CAM_EDM_DRO] Driver / Controller
>
> > On Sunday 08 December 2002 01:33 pm, you wrote:
> >
> > > With typical "hobby" PC based controller software, three techniques
> > are > applied. "Step and Direction" Signals are sent out of your
> > parallel port > to "motor Drivers", which in turn tell the motors
> > where to go and when.