Re: [CAD_CAM_EDM_DRO] Gecko 320 & 340

http://www.ktmarketing.com/CNC.html in the "How to's, instuctions,
documentation, etc" section. Second from the bottom labeled "Gecko G320
wiring how to diagram by Donald Brock"

It is not anything complicated. Logic to the computer and power supply wires
up just like a G201/210. 2 wires to the motor and then 4 wired to the
encoder. If the drive makes the motor jump and than faults immediately try
reversing the motor wires as you probably have the encode and motor working
in opposite directions. You could also reverse the A & B channel form the
encoder instead, but only change motor or encoder not both.

Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with Credit Card ordering
www.KTMarketing.com/Sherline
www.KTMarketing.com/DeskCNC

----- Original Message -----

> Hi
> Is there a place I can get a GENERAL wiring diagram for the Gecko 320
> Servo Drive .
> I'm familiar with steppers but have never used the servos ,and would
> like to see how they wire up with the encoders and all .
> No I couldn't find ANYTHING on geckodrive.com except the Installation
> notes .
>
> Thanks
> Ron K
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html