Re: [CAD_CAM_EDM_DRO] Gecko 320 & 340

Tim,
can you please give a link for a DRO info from Dan - I couldn't find it.
Alex

----- Original Message -----
From: Tim Goldstein <timg@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, January 03, 2003 1:26 PM
Subject: Re: [CAD_CAM_EDM_DRO] Gecko 320 & 340


> http://www.ktmarketing.com/CNC.html in the "How to's, instuctions,
> documentation, etc" section. Second from the bottom labeled "Gecko G320
> wiring how to diagram by Donald Brock"
>
> It is not anything complicated. Logic to the computer and power supply
wires
> up just like a G201/210. 2 wires to the motor and then 4 wired to the
> encoder. If the drive makes the motor jump and than faults immediately try
> reversing the motor wires as you probably have the encode and motor
working
> in opposite directions. You could also reverse the A & B channel form the
> encoder instead, but only change motor or encoder not both.
>
> Tim
> [Denver, CO]
> Sherline products at Deep Discount
> Mach1 & DeskCNC with Credit Card ordering
> www.KTMarketing.com/Sherline
> www.KTMarketing.com/DeskCNC
>
>
>
> ----- Original Message -----
>
> > Hi
> > Is there a place I can get a GENERAL wiring diagram for the Gecko 320
> > Servo Drive .
> > I'm familiar with steppers but have never used the servos ,and would
> > like to see how they wire up with the encoders and all .
> > No I couldn't find ANYTHING on geckodrive.com except the Installation
> > notes .
> >
> > Thanks
> > Ron K
> >
> >
> >
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>