RE: [CAD_CAM_EDM_DRO] beginners data on machine, software and servo selection

In case this may help some people, especially beginners, here is my my
most recent experience. I bought a set of these motors from this guy on
E-Bay
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=633&item=31052708
72, used Gecko drives
http://www.geckodrive.com/item.htbml?order_id=0&item_id=G320 on my Rong
Fu Gearhead Mill drill from Enco http://www.use-enco.com/ and it all
works GREAT. I used this parallel break out board
http://www.pmdx.com/index.html which is designed with the gecko servo
drivers in mind and I use Arts Mach1 controller http://www.artofcnc.ca/
which is by far the best value for the money out there.
I would have bought this mill but it was not in stock at the time.
http://www.lathemaster.com/HEAVYDUTYMILLINGMACHINE%207045FG.htm


Hope this helps a bit, feel free to ask questions.

David