a power supply question
Posted by
lum_l <lum_l@r...
on 2003-01-07 16:59:44 UTC
Hi All,
I am sorry if this question has been asked before.
I have purchased some steppers from Ebay, they are the
powermax II , max 65 volt, 1.75 amp.
(http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=12577
&item=3106027187) I also plan to use the xylotex driver board (3
axis).
My question is, what voltage and how many amp will require to
drive these motors.
The xylotex max voltage is 35 volts so I think I will need a supply
that will give me 30 volts @ 6 amps. Am I correct ? If not can
someone give the correct values. And does any one have a
source for surplus supplies?
Thanks for your help,
Les
I am sorry if this question has been asked before.
I have purchased some steppers from Ebay, they are the
powermax II , max 65 volt, 1.75 amp.
(http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=12577
&item=3106027187) I also plan to use the xylotex driver board (3
axis).
My question is, what voltage and how many amp will require to
drive these motors.
The xylotex max voltage is 35 volts so I think I will need a supply
that will give me 30 volts @ 6 amps. Am I correct ? If not can
someone give the correct values. And does any one have a
source for surplus supplies?
Thanks for your help,
Les
Discussion Thread
lum_l <lum_l@r...
2003-01-07 16:59:44 UTC
a power supply question
turbulatordude <davemucha@j...
2003-01-07 18:04:50 UTC
Re: a power supply question
Ron Kline
2003-01-07 18:30:39 UTC
Re: [CAD_CAM_EDM_DRO] a power supply question
sparkazoid2001 <mark@c...
2003-01-07 18:31:27 UTC
Re: a power supply question
jeffalanp <xylotex@h...
2003-01-07 19:03:54 UTC
Re: a power supply question
Tim Goldstein
2003-01-07 19:23:33 UTC
RE: [CAD_CAM_EDM_DRO] a power supply question
turbulatordude <davemucha@j...
2003-01-07 20:16:27 UTC
Re: a power supply question
Ron Kline
2003-01-07 20:21:30 UTC
Re: [CAD_CAM_EDM_DRO] a power supply question
turbulatordude <davemucha@j...
2003-01-08 08:39:32 UTC
Re: a power supply question