How to check Gecko G201?????
Posted by
ralaco <ralaco@y...
on 2003-01-16 09:48:18 UTC
Does somebody know how to check Gecko G201?
I tray to run a four 4 amp motor with a 36V 14 Amp 36,000uF power
supply.
Connecting:
1 Ground
2 Power
3 motors
4 motors
5 motors
6 motors
8 direction
9 step
10 5 volt
11 62K resistor
12 62K resistor
I checked the power in term 1 and 2 and it's ok, the led turns on,
but the motor do not get power.
I already try with the 4 geckos and it's the same.
How should I read the out power to the motors?
Best regards
Raul Lara
I tray to run a four 4 amp motor with a 36V 14 Amp 36,000uF power
supply.
Connecting:
1 Ground
2 Power
3 motors
4 motors
5 motors
6 motors
8 direction
9 step
10 5 volt
11 62K resistor
12 62K resistor
I checked the power in term 1 and 2 and it's ok, the led turns on,
but the motor do not get power.
I already try with the 4 geckos and it's the same.
How should I read the out power to the motors?
Best regards
Raul Lara
Discussion Thread
ralaco <ralaco@y...
2003-01-16 09:48:18 UTC
How to check Gecko G201?????
Alan Marconett KM6VV
2003-01-16 12:32:18 UTC
Re: [CAD_CAM_EDM_DRO] How to check Gecko G201?????
david_mucha <david_mucha@y...
2003-01-16 18:31:01 UTC
Re: How to check Gecko G201?????