Re: OpenCNC???
Posted by
PTENGIN@a...
on 2000-02-17 01:03:20 UTC
In a message dated 02/16/2000 6:54:20 PM Hawaiian Standard Time,
gpotter@... writes:
<< Does anyone know what this product is? >>
George,
I did some checking and I recall they are using D to A cards to control
the servos. I don't recall what brand but it was a little bit off the beaten
track. They were using a standard I/O card or something to track encoders.
All the information is on the web page but difficult to decipher.
Peter
gpotter@... writes:
<< Does anyone know what this product is? >>
George,
I did some checking and I recall they are using D to A cards to control
the servos. I don't recall what brand but it was a little bit off the beaten
track. They were using a standard I/O card or something to track encoders.
All the information is on the web page but difficult to decipher.
Peter
Discussion Thread
George Potter
2000-02-16 20:51:02 UTC
OpenCNC???
Matt Shaver
2000-02-16 21:20:39 UTC
Re: OpenCNC???
PTENGIN@a...
2000-02-17 01:03:20 UTC
Re: OpenCNC???