2 Axis readout, Battery powered
Posted by
jcc3inc <jccinc@o...
on 2003-01-16 13:11:49 UTC
Today I posted (4) photos of a 2 axis DRO using battery power.
Thank you very much to BOB SIMON who suggested Red Lion display units
for use in this type application. I put this together for checking
on the accuracy of my CNC control system, - an independent
verification. The photos are titled "Readout", "Front inside", "Back
inside" and "Encoder". The whole system was realtively low cost and
a heck of a lot faster than designing a ckt board, doing the circuit
with up-down counters etc. Some of Bob's data is in the Files
section, Red%20Lion%20DRO%20%Dis --- dated about 11-4-02. My pictures
are near the end of the photos section.
Regards,
Jack C. Cain
Thank you very much to BOB SIMON who suggested Red Lion display units
for use in this type application. I put this together for checking
on the accuracy of my CNC control system, - an independent
verification. The photos are titled "Readout", "Front inside", "Back
inside" and "Encoder". The whole system was realtively low cost and
a heck of a lot faster than designing a ckt board, doing the circuit
with up-down counters etc. Some of Bob's data is in the Files
section, Red%20Lion%20DRO%20%Dis --- dated about 11-4-02. My pictures
are near the end of the photos section.
Regards,
Jack C. Cain
Discussion Thread
jcc3inc <jccinc@o...
2003-01-16 13:11:49 UTC
2 Axis readout, Battery powered
Bob Simon
2003-01-16 13:26:31 UTC
Re: [CAD_CAM_EDM_DRO] 2 Axis readout, Battery powered
pwrcntrl <info@c...
2003-01-16 13:45:52 UTC
Re: 2 Axis readout, Battery powered