Re: macintosh links ?
Posted by
ballendo <ballendo@y...
on 2003-01-18 03:12:19 UTC
Hello,
The only CNC software I am aware of for the mac is Neil Gillies
project at seagull technologies; and there was a man named Peter
Ohler in the San Jose area around 1994 that had a product called
cyberengraver. It required the use of a card from Dave Downs at TMG
(the motion Group, also in San Jose)
Hope this helps,
Ballendo
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "ianemmerson <ian@e...>"
<ian@e...> wrote:
The only CNC software I am aware of for the mac is Neil Gillies
project at seagull technologies; and there was a man named Peter
Ohler in the San Jose area around 1994 that had a product called
cyberengraver. It required the use of a card from Dave Downs at TMG
(the motion Group, also in San Jose)
Hope this helps,
Ballendo
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "ianemmerson <ian@e...>"
<ian@e...> wrote:
> Greetings to all,
> Just been given 2 macintosh Classics.(cute little things)
> both in a1 condition, wondered if i could use one to
> control a single stepper size 23. anyone got any links
> for software, hardware, or any info ? they are just the right
> size to fit in my very cramped workshop,or perhaps i could
> use the monitors with a PC.
> grateful for any help
> Ian.
Discussion Thread
ianemmerson <ian@e...
2003-01-17 17:03:50 UTC
macintosh links ?
ballendo <ballendo@y...
2003-01-18 03:12:19 UTC
Re: macintosh links ?
James C. Wilson
2003-01-18 22:07:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: macintosh links ?