Re: EMC software and ServoToGo board.
Posted by
Jon Elson
on 2000-02-17 13:01:07 UTC
mika.salmi@... wrote:
tested the
support on these cards, but if not, they probably will by the time you
could get
one.
Jon
> From: mika.salmi@...They (NIST) are working on it. I don't know if they have finished and
>
> Hello!
> I�m new member of this forum and i just start retrofiting my knee type
> mill.
> Can some one tell can i use ServoToGo stage 2 board whit EMC software.
tested the
support on these cards, but if not, they probably will by the time you
could get
one.
Jon
Discussion Thread
Jon Elson
2000-02-17 13:01:07 UTC
Re: EMC software and ServoToGo board.
Fred Proctor
2000-02-23 08:47:13 UTC
Re: EMC software and ServoToGo board.
John Guenther
2000-02-23 08:56:23 UTC
Re: EMC software and ServoToGo board.
Jan
2000-02-24 04:57:05 UTC
Re: EMC software and ServoToGo board.
Fred Proctor
2000-02-24 06:19:34 UTC
Re: EMC software and ServoToGo board.