Re: EMC software and ServoToGo board.

Fred,


Servo To Go users,

The EMC includes a software interface to the Servo To Go that should work with both Model 1 and Model 2 boards. The source We don't have a Model 2 board here, so we haven't tested it. We took the
latest driver from Servo To Go's web site, which handles both models,
and ported it. It works for the Model 1. Testers, please...

--Fred

Jan-release RH5.2 K2.0.36
Tried now to put some voltage on the DAC's. Which 'minerror' put very high a can run a program, when jogging (+ -) an axis seeing on a scoop the change in voltage (+ -).

Tried also STG- linux- program:
Changed bit A1 =P1/45 = + X limit , nothing happens
Changing bit A2=P1/43 = - X limit , indication in TkEmc X goes red.
Changing bit A3=P1/41 = X amp fault , indication in TkEmc X goes red.
Same thing happens with Y and Z axis.
Was this also the fact in stgmod.o ? I remember changing bit A7 to go out of Y-limit when working which my (broken) model 1 board or is my STG Configuration out of date?
Jan.


[Non-text portions of this message have been removed]