clean plasma
Posted by
Joe Vicars
on 2000-02-18 11:21:40 UTC
Any words of wisdom for getting slag-free plasma cuts? The material
thickness is between .030-.060 in. I have a Lincoln Pro-Cut 55 ,
minimum of 25 amps. My machine will feed up to 100ipm.
Are there any rules of thumb? I have not been able to get
consistent results, and frequently leave a trail of slag underneath and
behind the arc.
thickness is between .030-.060 in. I have a Lincoln Pro-Cut 55 ,
minimum of 25 amps. My machine will feed up to 100ipm.
Are there any rules of thumb? I have not been able to get
consistent results, and frequently leave a trail of slag underneath and
behind the arc.
Discussion Thread
Joe Vicars
2000-02-18 11:21:40 UTC
clean plasma
PTENGIN@a...
2000-02-18 12:05:29 UTC
Re: clean plasma
Joe Vicars
2000-02-18 13:02:44 UTC
Re: clean plasma
Steve Carlisle
2000-02-18 17:09:19 UTC
Re: clean plasma
Jay Hayes
2000-02-18 17:03:03 UTC
Re: clean plasma