Re: spindle to motor connection
Posted by
Randy Gordon-Gilmore
on 2003-01-23 10:31:01 UTC
At 12:47 PM 1/23/2003 -0000, Ballendo wrote:
http://www.progressivesignsystems.com/roland/engravers/egx-30.htm) uses
this approach, but with a round belt. There is a 3:1 stepup between the
motor and spindle, and the wide pulley is on the motor.
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.prototrains.com
>In use, the belt "follows" along with the narrower pulley as it movesThe Roland EGX-30 (formerly CS-20) desktop engraving machine (see
>up and down the longer right cylinder pulley. Which on the motor, and
http://www.progressivesignsystems.com/roland/engravers/egx-30.htm) uses
this approach, but with a round belt. There is a 3:1 stepup between the
motor and spindle, and the wide pulley is on the motor.
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.prototrains.com
Discussion Thread
Ivan Nichols <ouisel@v...
2003-01-22 05:08:50 UTC
CAD_CAM_EDM_DRO spindle to motor connection
Marcus & Eva
2003-01-22 08:16:51 UTC
Re: [CAD_CAM_EDM_DRO] CAD_CAM_EDM_DRO spindle to motor connection
CL
2003-01-22 10:37:45 UTC
Re: [CAD_CAM_EDM_DRO] CAD_CAM_EDM_DRO spindle to motor connection
ballendo <ballendo@y...
2003-01-23 04:47:59 UTC
Re: CAD_CAM_EDM_DRO spindle to motor connection
Hoyt McKagen
2003-01-23 07:30:35 UTC
spindle to motor connection
Randy Gordon-Gilmore
2003-01-23 10:31:01 UTC
Re: spindle to motor connection
ballendo <ballendo@y...
2003-01-23 11:23:14 UTC
Re: spindle to motor connection
ballendo <ballendo@y...
2003-01-23 11:36:13 UTC
Re: spindle to motor connection