Re: [CAD_CAM_EDM_DRO] 4th axis and EMC
Posted by
EdFanta
on 2003-01-25 19:05:42 UTC
Tim Goldstein wrote:
head seems to be working fine. Thanks for the tips from Tim,Paul and
Ray. Tim and Ray: Adding the A after XYZ and adding the 0 on the line
under along with cutting and pasting the axis info worked great. I have
been playing around with the speeds to get the top RPM on the A axis, if
the X is programmed for a short lead the A cannot spin fast enough to
keep up and it gives a following error. Paul: I am running BDI 2.16 so
it still has the references to PARPORT_IO_ADDRESS, not a problem on my
end and it seems to be running good. The next problem I have is, how do
you jog the A axis? Somewhere was a reference to using HOME and END keys
but HOME is used in this case to zero the axises and END doesn't do
anything. Thanks again fellows. Ed.
>Progress has been made!! The addition of a servo motor to a dividing
> I believe those files are only for the previous versions of EMC. With
> BDI you just put on the proper number of axis and definitions in the
> .ini file and TKEMC then comes up with them if you are not using
> steppermod.o. I may be wrong, but that is my recollection.
>
head seems to be working fine. Thanks for the tips from Tim,Paul and
Ray. Tim and Ray: Adding the A after XYZ and adding the 0 on the line
under along with cutting and pasting the axis info worked great. I have
been playing around with the speeds to get the top RPM on the A axis, if
the X is programmed for a short lead the A cannot spin fast enough to
keep up and it gives a following error. Paul: I am running BDI 2.16 so
it still has the references to PARPORT_IO_ADDRESS, not a problem on my
end and it seems to be running good. The next problem I have is, how do
you jog the A axis? Somewhere was a reference to using HOME and END keys
but HOME is used in this case to zero the axises and END doesn't do
anything. Thanks again fellows. Ed.
Discussion Thread
EdFanta
2003-01-20 14:57:12 UTC
4th axis and EMC
Tim Goldstein
2003-01-20 15:01:04 UTC
RE: [CAD_CAM_EDM_DRO] 4th axis and EMC
EdFanta
2003-01-20 15:37:00 UTC
Re: [CAD_CAM_EDM_DRO] 4th axis and EMC
Paul
2003-01-20 15:59:51 UTC
Re: [CAD_CAM_EDM_DRO] 4th axis and EMC
EdFanta
2003-01-25 19:05:42 UTC
Re: [CAD_CAM_EDM_DRO] 4th axis and EMC
Ray Henry
2003-01-26 07:28:42 UTC
Re: Re: 4th axis and EMC
EdFanta
2003-01-27 07:04:43 UTC
Re: [CAD_CAM_EDM_DRO] Re: Re: 4th axis and EMC