Re: [CAD_CAM_EDM_DRO] selsyn motors
Posted by
Jon Elson
on 2003-01-26 22:54:17 UTC
hllrsr@... wrote:
move the pointer
on a dial without adding amplifiers. Why not have the tracer probe move
a shaft encoder or
swing a vane in front of proportional photosensors. That could drive a
servo amplifier or
a fairly simple circuit to drive a step/direction stepper driver.
Jon
>Jon,Huh? How would the receiver move the cutter? These things barely can
>They where recommended as a solution to a problem I am having trying to
>make a tracer attachment for my mill.
>I was considering a hydraulic tracer, but it was suggested that I use a
>spring loaded tracer attached to the selsyn transmitter as the master,
>and use the reciever to move the cutter so as to follow the contours of
>my pattern.
>Turbcnc would drive the master table (with the other table slaved to it)
>and at the end of the programmed search routine,the master and copy
>would rotate to the new surface to be traced/machined.
>
>Do-able?
>
>
move the pointer
on a dial without adding amplifiers. Why not have the tracer probe move
a shaft encoder or
swing a vane in front of proportional photosensors. That could drive a
servo amplifier or
a fairly simple circuit to drive a step/direction stepper driver.
Jon
Discussion Thread
hllrsr@c...
2003-01-26 16:46:47 UTC
selsyn motors
Jon Elson
2003-01-26 18:00:50 UTC
Re: [CAD_CAM_EDM_DRO] selsyn motors
Marv Frankel
2003-01-26 18:16:50 UTC
Re: [CAD_CAM_EDM_DRO] selsyn motors
hllrsr@c...
2003-01-26 18:22:42 UTC
Re: [CAD_CAM_EDM_DRO] selsyn motors
hllrsr@c...
2003-01-26 18:25:33 UTC
Re: [CAD_CAM_EDM_DRO] selsyn motors
Jon Elson
2003-01-26 22:50:28 UTC
Re: [CAD_CAM_EDM_DRO] selsyn motors
Jon Elson
2003-01-26 22:54:17 UTC
Re: [CAD_CAM_EDM_DRO] selsyn motors
Alan Marconett KM6VV
2003-01-27 11:29:32 UTC
Re: [CAD_CAM_EDM_DRO] selsyn motors
echnidna <echnidna@y...
2003-01-27 15:29:03 UTC
Re: selsyn motors
echnidna <echnidna@y...
2003-01-28 15:44:42 UTC
Re: selsyn motors