Torque when using Micro Step or Full Step
Posted by
Hans Wedemeyer
on 2003-02-02 16:42:04 UTC
I'm still mulling over the lack of startup power this PACSI motor has , and was wondering if there
is much difference in torque output Micro Step and Full Step.
The Gecko 201 only does micro-step.
Would there be any increase in torque using Full Step as compared to Micro Step ?
Best Regards
Hans W
is much difference in torque output Micro Step and Full Step.
The Gecko 201 only does micro-step.
Would there be any increase in torque using Full Step as compared to Micro Step ?
Best Regards
Hans W
Discussion Thread
Hans Wedemeyer
2003-02-02 16:42:04 UTC
Torque when using Micro Step or Full Step
Mariss Freimanis <mariss92705@y...
2003-02-02 17:14:24 UTC
Re: Torque when using Micro Step or Full Step
Hans Wedemeyer
2003-02-02 17:53:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: Torque when using Micro Step or Full Step
Mariss Freimanis <mariss92705@y...
2003-02-02 18:07:33 UTC
Re: Torque when using Micro Step or Full Step
Hans Wedemeyer
2003-02-02 18:14:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: Torque when using Micro Step or Full Step
Mariss Freimanis <mariss92705@y...
2003-02-02 18:40:00 UTC
Re: Torque when using Micro Step or Full Step
Hans Wedemeyer
2003-02-02 19:11:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: Torque when using Micro Step or Full Step
echnidna <echnidna@y...
2003-02-03 15:36:08 UTC
Re: Question to Mariss about demagnetion was Re: Torque when usin
echnidna <echnidna@y...
2003-02-03 20:16:16 UTC
Question to Mariss about demagnetion was Re: Torque when usin
echnidna <echnidna@y...
2003-02-03 21:18:13 UTC
Question to Mariss about demagnetion was Re: Torque when usin
William Scalione
2003-02-03 23:27:42 UTC
Re: [CAD_CAM_EDM_DRO] Question to Mariss about demagnetion was Re: Torque when usin
Tony Jeffree
2003-02-04 03:25:06 UTC
Re: [CAD_CAM_EDM_DRO] Question to Mariss about demagnetion was Re: Torque when usin
Hoyt McKagen
2003-02-04 04:32:47 UTC
Re: [CAD_CAM_EDM_DRO] Question to Mariss about demagnetion was Re: Torque when usin