Re: Question to Mariss about demagnetion was Re: Torque when usin
Posted by
echnidna <echnidna@y...
on 2003-02-03 15:36:08 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Mariss Freimanis <mariss92705@y...>" <mariss92705@y...> wrote:
but would dismantling a stepper for a short time to fit new bearings be likely to cause any significant loss of magnetism
Regards
Bob Thomas
> .... Regarding your motor. Check carefully to see if it has not beenMariss, I assume dismantling a stepper motor and leaving it that way for some time could demagnetise it.
> disassembled. Look for marks on its screws. A step motor that has had
> its rotor removed from the stator can lose a lot of its rated torque
> due to demagnetization.
>
> Mariss
but would dismantling a stepper for a short time to fit new bearings be likely to cause any significant loss of magnetism
Regards
Bob Thomas
Discussion Thread
Hans Wedemeyer
2003-02-02 16:42:04 UTC
Torque when using Micro Step or Full Step
Mariss Freimanis <mariss92705@y...
2003-02-02 17:14:24 UTC
Re: Torque when using Micro Step or Full Step
Hans Wedemeyer
2003-02-02 17:53:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: Torque when using Micro Step or Full Step
Mariss Freimanis <mariss92705@y...
2003-02-02 18:07:33 UTC
Re: Torque when using Micro Step or Full Step
Hans Wedemeyer
2003-02-02 18:14:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: Torque when using Micro Step or Full Step
Mariss Freimanis <mariss92705@y...
2003-02-02 18:40:00 UTC
Re: Torque when using Micro Step or Full Step
Hans Wedemeyer
2003-02-02 19:11:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: Torque when using Micro Step or Full Step
echnidna <echnidna@y...
2003-02-03 15:36:08 UTC
Re: Question to Mariss about demagnetion was Re: Torque when usin
echnidna <echnidna@y...
2003-02-03 20:16:16 UTC
Question to Mariss about demagnetion was Re: Torque when usin
echnidna <echnidna@y...
2003-02-03 21:18:13 UTC
Question to Mariss about demagnetion was Re: Torque when usin
William Scalione
2003-02-03 23:27:42 UTC
Re: [CAD_CAM_EDM_DRO] Question to Mariss about demagnetion was Re: Torque when usin
Tony Jeffree
2003-02-04 03:25:06 UTC
Re: [CAD_CAM_EDM_DRO] Question to Mariss about demagnetion was Re: Torque when usin
Hoyt McKagen
2003-02-04 04:32:47 UTC
Re: [CAD_CAM_EDM_DRO] Question to Mariss about demagnetion was Re: Torque when usin