CAD CAM EDM DRO - Yahoo Group Archive

Re: THK Linear Bearing/Slide

on 2003-02-13 13:52:12 UTC
Linear rails and trucks are almost always preloaded to help them
handle large loads relative to their size. Thus, if you push against
the truck towards the rail while you try to slide it, you'll find
that it is much easier to move left and right.

-Chris
http://www.slideruleracing.com

> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "Fusion X Studio"
> <fusionxstudio@h...> wrote:
> > I have bought a couple of THK linear slide units and both are like
> new. Are
> > they supossed to slide very easily? These aren't rough, just not
> easy to
> > slide. they are clean and greased. I have bought many thomson
linear
> > bearings with the rods and they are smooth and easy but don't
seem to be
> > tight. Have a little play in them. It seems you would rather a
> smooth
> > bearing than something that is hard to slide?? Is that the way
most of
> > these THK bearings should be?
> >
> > Thanks,
> >
> > Barclay

Discussion Thread

Fusion X Studio 2003-02-12 11:12:55 UTC THK Linear Bearing/Slide Robert Campbell 2003-02-12 11:31:11 UTC Re: [CAD_CAM_EDM_DRO] THK Linear Bearing/Slide Fusion X Studio 2003-02-12 12:12:31 UTC Re: [CAD_CAM_EDM_DRO] THK Linear Bearing/Slide aerowright <mnemesh@m... 2003-02-13 07:08:06 UTC Re: THK Linear Bearing/Slide Chris and Dee <brunoblazer@y... 2003-02-13 13:52:12 UTC Re: THK Linear Bearing/Slide