CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Re: plasma setup-leadscrew vs. rack & pinio n + software

on 2003-02-21 03:20:51 UTC
Hello, Ballendo,
I saw once on this forum, roller chain is NOT enough linear for CNC
machines.
So, you recommend it again ?

And, I can't find an email address of Plasmacam, Inc on plasmacam.com. Do
you have it?
Peja

-----Original Message-----
From: ballendo <ballendo@...> [mailto:ballendo@...]
Sent: Thursday, February 20, 2003 3:25 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Re: plasma setup-leadscrew vs. rack & pinion
+ software


Hello,

Roller chain (#25, or even bicycle chain) can work really well for
plasma. Fix the chain at both ends, and move the motor/sprocket. An
idler sprocket or two adds "wrap" to the motor sprocket. If your
motors are small, try a 4:1 reduction before the final output. BTW,
this will work for routers too...

Hope this helps,

Ballendo


www.plasmacam.com
> for some ideas about rack and pinion setups.
>
> Drop me a line off list and I can go into detail about the THC
plans
> and some ideas for torch holders.


Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com

Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
Moderator: pentam@... indigo_red@... [Moderators]
URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO

OFF Topic POSTS: General Machining
If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
http://www.metalworking.com/news_servers.html

http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.

NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
bill
List Mom
List Owner



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Discussion Thread

Miroslav Pejic 2003-02-21 03:20:51 UTC RE: [CAD_CAM_EDM_DRO] Re: plasma setup-leadscrew vs. rack & pinio n + software turbulatordude <davemucha@j... 2003-02-21 05:57:55 UTC Re: plasma setup-leadscrew vs. rack & pinio n + software ballendo <ballendo@y... 2003-02-21 12:30:43 UTC Re: plasma setup-leadscrew vs. rack & pinio n + software Miroslav Pejic 2003-02-21 23:37:38 UTC RE: [CAD_CAM_EDM_DRO] Re: plasma setup-leadscrew vs. rack & pinio n + software