CAD CAM EDM DRO - Yahoo Group Archive

Parts cutout technique?

Posted by bdrmachine <bdrmachine@h...

on 2003-02-22 14:43:34 UTC

I'm finally making chips with my cnc mill, but not much more.
I have a 2.5 inch connecting rod that I'm cutting out of the middle
of a .375 T6061 AL plate. The rod gets marred up / damaged during
the final cut. Are there any suggestions / techniques to prevent
this?

Thanks
Brian

Discussion Thread

bdrmachine <bdrmachine@h... 2003-02-22 14:43:34 UTC Parts cutout technique? turbulatordude <davemucha@j... 2003-02-22 16:21:41 UTC Re: Parts cutout technique? bdrmachine <bdrmachine@h... 2003-02-22 17:30:32 UTC Re: Parts cutout technique? fuddham@a... 2003-02-22 17:35:59 UTC Re: [CAD_CAM_EDM_DRO] Re: Parts cutout technique? Monte Westlund <montejw@e... 2003-02-22 17:42:43 UTC Re: Parts cutout technique? Raymond Heckert 2003-02-22 17:44:23 UTC Re: [CAD_CAM_EDM_DRO] Parts cutout technique? turbulatordude <davemucha@j... 2003-02-22 17:59:08 UTC Re: Parts cutout technique? bdrmachine <bdrmachine@h... 2003-02-23 05:18:27 UTC Re: Parts cutout technique? ballendo <ballendo@y... 2003-02-23 08:26:28 UTC Re: Parts cutout technique?