Re: Parts cutout technique?
Posted by
Monte Westlund <montejw@e...
on 2003-02-22 17:42:43 UTC
I've seen one shop doing wind tunnel models, machining wing sections
from both sides of the stock. They would leave a thin rib of
material holding the part in place, never actually cutting the part
totally out of the stock. They would just pop it out by hand and had
finish the thin rib of material left over around the edges.
Monte
from both sides of the stock. They would leave a thin rib of
material holding the part in place, never actually cutting the part
totally out of the stock. They would just pop it out by hand and had
finish the thin rib of material left over around the edges.
Monte
Discussion Thread
bdrmachine <bdrmachine@h...
2003-02-22 14:43:34 UTC
Parts cutout technique?
turbulatordude <davemucha@j...
2003-02-22 16:21:41 UTC
Re: Parts cutout technique?
bdrmachine <bdrmachine@h...
2003-02-22 17:30:32 UTC
Re: Parts cutout technique?
fuddham@a...
2003-02-22 17:35:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: Parts cutout technique?
Monte Westlund <montejw@e...
2003-02-22 17:42:43 UTC
Re: Parts cutout technique?
Raymond Heckert
2003-02-22 17:44:23 UTC
Re: [CAD_CAM_EDM_DRO] Parts cutout technique?
turbulatordude <davemucha@j...
2003-02-22 17:59:08 UTC
Re: Parts cutout technique?
bdrmachine <bdrmachine@h...
2003-02-23 05:18:27 UTC
Re: Parts cutout technique?
ballendo <ballendo@y...
2003-02-23 08:26:28 UTC
Re: Parts cutout technique?