motor voltage
Posted by
Owen Lloyd
on 2003-02-24 09:56:36 UTC
My CNC hardware provider recommends I check my motor volts at the Gecko
Terminals [inside the blue box] to ensure a full 22v.
Rather than open the box, can I check them at the motor terminals? Would not
the voltage be the same? Is there a noticeable drop in voltage over such a
short wire span that it would not be accurate?
Any advice in this regards.
thank you.
Owen
Terminals [inside the blue box] to ensure a full 22v.
Rather than open the box, can I check them at the motor terminals? Would not
the voltage be the same? Is there a noticeable drop in voltage over such a
short wire span that it would not be accurate?
Any advice in this regards.
thank you.
Owen
Discussion Thread
Owen Lloyd
2003-02-24 09:56:36 UTC
motor voltage
Tony Jeffree
2003-02-24 10:43:15 UTC
Re: [CAD_CAM_EDM_DRO] motor voltage
JanRwl@A...
2003-02-25 14:49:25 UTC
Re: [CAD_CAM_EDM_DRO] motor voltage
Andrew Mawson <andrew@m...
2003-02-25 15:08:01 UTC
Re: motor voltage
Tony Jeffree
2003-02-25 15:22:28 UTC
Re: [CAD_CAM_EDM_DRO] motor voltage