RE: [CAD_CAM_EDM_DRO] Re: what is POSTPROCESSOR? a fundamental question

Open most any PC computer and that is what modern controllers look like
inside for the most part. If you are using EMC, Mach1, TurboCNC, CNCPro,
DeskCNC, etc the controller is your PC.

Most controllers do not take DXF code. They take the G-code that was
generated from your CAM program or post processor.

Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline
Now selling Visual Mill

> -----Original Message-----
>
> Then, the next question is where can I find a suitable
> circuit diagram for a controller? Are there any commercial
> ones available? And why would I choose one over another? I
> am assuming that controllers differ mostly in the EEPROM that
> contains the G-code interpreter for the DXF code delivered to it.
>
> JerryK