CAD CAM EDM DRO - Yahoo Group Archive

Re: Mach1 Question?????

Posted by vrsculptor
on 2003-03-06 14:51:52 UTC
Raul,
Did you press the apply button?

Roger
> I cant save the sets from the configuration
>
> I installed Mach1, but I can't set the pin configuration, if I
open
> Printer Port Output Pins Tab and set the pins, then go to Input
> Signals Tab and set the limits and activation, if I go back to
Port
> Output the changes where not saved and so on.
> If I try to move the motors, they do not move but nether the DROs.
>
> Does somebody knows what's happening?
>
> Best regards
> Raul Lara

Discussion Thread

ralaco 2003-03-06 14:15:07 UTC Mach1 Question????? vrsculptor 2003-03-06 14:51:52 UTC Re: Mach1 Question????? ralaco 2003-03-06 17:10:30 UTC Re: Mach1 Question?????