Re: Mach1 Question?????

Roger

I just installed Windows XP and I didn't change the monitor
configuration.
So it was set to 640 X 480 and I couldn't see the apply button.

Thank you
Raul Lara



--- In CAD_CAM_EDM_DRO@yahoogroups.com, "vrsculptor"
<vrsculptor@h...> wrote:

> Raul,
> Did you press the apply button?
>
> Roger
> > I cant save the sets from the configuration
> >
> > I installed Mach1, but I can't set the pin configuration, if I
> open
> > Printer Port Output Pins Tab and set the pins, then go to Input
> > Signals Tab and set the limits and activation, if I go back to
> Port
> > Output the changes where not saved and so on.
> > If I try to move the motors, they do not move but nether the DROs.
> >
> > Does somebody knows what's happening?
> >
> > Best regards
> > Raul Lara