Mach1 Question?????
Posted by
ralaco
on 2003-03-06 14:15:07 UTC
I cant save the sets from the configuration
I installed Mach1, but I can't set the pin configuration, if I open
Printer Port Output Pins Tab and set the pins, then go to Input
Signals Tab and set the limits and activation, if I go back to Port
Output the changes where not saved and so on.
If I try to move the motors, they do not move but nether the DROs.
Does somebody knows what's happening?
Best regards
Raul Lara
I installed Mach1, but I can't set the pin configuration, if I open
Printer Port Output Pins Tab and set the pins, then go to Input
Signals Tab and set the limits and activation, if I go back to Port
Output the changes where not saved and so on.
If I try to move the motors, they do not move but nether the DROs.
Does somebody knows what's happening?
Best regards
Raul Lara
Discussion Thread
ralaco
2003-03-06 14:15:07 UTC
Mach1 Question?????
vrsculptor
2003-03-06 14:51:52 UTC
Re: Mach1 Question?????
ralaco
2003-03-06 17:10:30 UTC
Re: Mach1 Question?????