CAD CAM EDM DRO - Yahoo Group Archive

Re: resonance and controllers

Posted by Joel Jacobs
on 2000-02-25 12:36:51 UTC
Some poorly written software fails to use the hardware timer and trys to
program the delays between steps with software loops. The problem is that
they don't dis-able interrupts to do the software loops so the timing gets
all whacked out when the processor goes off to refresh the memory or
something.

Joel


----- Original Message -----
From: "Joe Vicars" <jvicars@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Friday, February 25, 2000 1:59 PM
Subject: [CAD_CAM_EDM_DRO] resonance and controllers


> From: Joe Vicars <jvicars@...>
>
> I don't understand how the software control contributed to the
> resonance problem that Tim described. The software controller just
> outputs a square wave of varying frequency. If you have control over
> your instantaneous start, accel and decel, then you should be able to
> find an operating range that works. What am I missing?
>
>
> ------------------------------------------------------------------------
> Shop the web for great deals. Save on Computers,
> electronics, Home furnishings and more.
> http://click.egroups.com/1/1559/2/_/423600/_/951505179/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>

Discussion Thread

Joe Vicars 2000-02-25 10:59:09 UTC resonance and controllers Joel Jacobs 2000-02-25 12:36:51 UTC Re: resonance and controllers Tim Goldstein 2000-02-25 13:05:19 UTC Re: resonance and controllers Darrell 2000-02-25 15:37:03 UTC Re: resonance and controllers Harrison, Doug 2000-02-28 06:18:25 UTC RE: resonance and controllers