CAD CAM EDM DRO - Yahoo Group Archive

RE: resonance and controllers

on 2000-02-28 06:18:25 UTC
> -----Original Message-----
> From: Joe Vicars [SMTP:jvicars@...]
> Sent: Friday, February 25, 2000 1:59 PM
> To: CAD_CAM_EDM_DRO@onelist.com
> Subject: [CAD_CAM_EDM_DRO] resonance and controllers
>
> From: Joe Vicars <jvicars@...>
>
> I don't understand how the software control contributed to the
> resonance problem that Tim described. The software controller just
> outputs a square wave of varying frequency. If you have control over
> your instantaneous start, accel and decel, then you should be able to
> find an operating range that works. What am I missing?
>
Some programs are not very good at accurately spacing the step
pulses. The variation in timing shows up as harmonics and the effects are
significant.

Doug

Discussion Thread

Joe Vicars 2000-02-25 10:59:09 UTC resonance and controllers Joel Jacobs 2000-02-25 12:36:51 UTC Re: resonance and controllers Tim Goldstein 2000-02-25 13:05:19 UTC Re: resonance and controllers Darrell 2000-02-25 15:37:03 UTC Re: resonance and controllers Harrison, Doug 2000-02-28 06:18:25 UTC RE: resonance and controllers