Re: Suitable for lathe ???
Posted by
monoflyer
on 2003-03-17 12:40:24 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Alan Marconett KM6VV
<KM6VV@a...> wrote:
were 7 kilograms per centimeter. What would that work out to in
ounces and inches?
<KM6VV@a...> wrote:
> Hi flyer,foam,
>
> On a cursory examination, this driver/motor package is for cutting
> and will have very light weight motors and oz/in. This would notbe
> suitable for a 10 x 18 lathe! 1.2A unipolar, 24V would notprovide much
> drive (motor specs not available). Requirements very, you maywant/need
> from 350 oz/in to perhaps closer to 600, depending on gearing andspeeds
> you require.The specs I found on the motors were metric, they said that they
>
> HTH
>
> Alan KM6VV
>
were 7 kilograms per centimeter. What would that work out to in
ounces and inches?
>would be
> monoflyer wrote:
> >
> > Hi Guy's, I was just wondering if this driver/motor package
> > suitable to use on my new 10 X 18 lathe ? And if not what wouldbe
> > recomended, i'm finding the choices overwhelming. Found thiswhile
> > surfing model sites. http://www.foamlinx.com/products.htm
Discussion Thread
monoflyer
2003-03-17 04:01:29 UTC
Suitable for lathe ???
Tim Goldstein
2003-03-17 08:20:47 UTC
RE: [CAD_CAM_EDM_DRO] Suitable for lathe ???
Alan Marconett KM6VV
2003-03-17 11:17:47 UTC
Re: [CAD_CAM_EDM_DRO] Suitable for lathe ???
monoflyer
2003-03-17 12:40:24 UTC
Re: Suitable for lathe ???
Alan Marconett KM6VV
2003-03-17 14:51:22 UTC
Re: Suitable for lathe ???