CAD CAM EDM DRO - Yahoo Group Archive

Half Coil

Posted by P. J. Hicks
on 2003-03-19 14:26:43 UTC
Reading past posts on running steppers in 'Half Coil' configuration has left me a little confused.
If configured in 'Half Coil' can the amps be doubled? Run at 1.414 times rated? Name plate amp rating never exceeded?

I have PacSci PowerMax II motors rated 0.82 amp., Max Vdc = 65, 31 watts. Currently setup on 24 volts, 0.75amps, 1/8 step with Xylotex driver. Would like a little more power output.
PJH

[Non-text portions of this message have been removed]

Discussion Thread

P. J. Hicks 2003-03-19 14:26:43 UTC Half Coil Tony Jeffree 2003-03-20 00:44:16 UTC Re: [CAD_CAM_EDM_DRO] Half Coil turbulatordude 2003-03-20 05:16:35 UTC Re: Half Coil