Re: Any one have a 3 axis DRO designed for SPC output Calipers.

http://www.zietlowdesign.com/products/products.htm

scales are NOT included.

can display RPM or SFM for a lathe, or set to read half value for
diameter on a lathe.

only 2 axis display, you would either need to wait a week or 2 or get
2 units.




--- In CAD_CAM_EDM_DRO@yahoogroups.com, "capteod" <mfgguru@e...>
wrote:

> Has anyone designed a simple 3 axis readout that canuse the output
> from the CHEAP Harbor freight Calipers as scales. This would be a
> simple project and I believe it might make an interestiing project
> for a good electronic designer. The files on the Calipers is in

our

> FILES area.
>
> I know that a commercial unit is available for $250.00, and if it

is

> being sold of that it must cost less than $75.00 in parts. This is
> a challange to the electronic GURU's in the group.