SPC Cables
Posted by
dholling2002
on 2003-03-31 07:37:56 UTC
New to the group, but have found volumes of information in just a
short time. I am awaiting the delivery of a new mill from
Lathemaster and have been working with the digital scales for a DRO.
I am looking for a source for the cables or just the connectors for
the SPC output.
The system I have built uses a CPLD for the serial data and a PIC for
filtering, computation and output to the LEDs. If I can find the
connectors I have plans to build a small board to hold a DC-to-DC
converter (5VDC to 1.5Vdc)to supply power and an op-amp pair to boost
the output signals. You won't believe how small these components
are. DC-to-DC less than 1 mm square, LM293 about 1.5 mm sq. so
should fit very nicely right at the gages with very few noise
problems.
Would love to hear from anyone with a source for the cable or
connector.
TIA,
DrH
short time. I am awaiting the delivery of a new mill from
Lathemaster and have been working with the digital scales for a DRO.
I am looking for a source for the cables or just the connectors for
the SPC output.
The system I have built uses a CPLD for the serial data and a PIC for
filtering, computation and output to the LEDs. If I can find the
connectors I have plans to build a small board to hold a DC-to-DC
converter (5VDC to 1.5Vdc)to supply power and an op-amp pair to boost
the output signals. You won't believe how small these components
are. DC-to-DC less than 1 mm square, LM293 about 1.5 mm sq. so
should fit very nicely right at the gages with very few noise
problems.
Would love to hear from anyone with a source for the cable or
connector.
TIA,
DrH
Discussion Thread
dholling2002
2003-03-31 07:37:56 UTC
SPC Cables
ccq@x...
2003-03-31 11:54:20 UTC
Re: [CAD_CAM_EDM_DRO] SPC Cables
Chris Baugher
2003-03-31 21:45:18 UTC
Re: [CAD_CAM_EDM_DRO] SPC Cables