Re: Sanity check on home switches

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Jeff Goldberg" <jeff@w...>
wrote:

> Dave:
>
> Do you happen to know how MACH1 (2) handles this? The

documentation is a

> little fuzzy. I can hook up a jog (or bypass) switch, but it seems
> redundant if the software handles it.
>

I have been watching the posts over on the Master5 board and the
recent discussion of the TCH (torch height control) as typically used
on plasma cutters.

http://groups.yahoo.com/group/Master5

check on that list to see.

Dave

>
>
> -----Original Message-----
> From: turbulatordude [mailto:davemucha@j...]
> Sent: Wednesday, April 09, 2003 9:23 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] Re: Sanity check on home switches
>
> Hi Jeff,
>
> check the software and see if it dies on an end switch. some

require

> you to manually clear the error before it can run.
>
> ditto for limit switches that kill power. that means that although
> you can go home again, you can can only walk away.
>
> Dave