Advise on a HF Mini Mill z-axis conversion
Posted by
shawnusa2002
on 2003-04-18 13:05:13 UTC
I'm in the process of converting my Mini Mill into CNC and was
hoping to tape your knowledge. Would a balll and lead screw Shaft
that is 3/4" diameter, and pitch is 1/2" per turn be a good choice
for the Z axis of the Mini Mill? If not, what ideally should I be
looking for?
Cheers,
Shawn
hoping to tape your knowledge. Would a balll and lead screw Shaft
that is 3/4" diameter, and pitch is 1/2" per turn be a good choice
for the Z axis of the Mini Mill? If not, what ideally should I be
looking for?
Cheers,
Shawn
Discussion Thread
shawnusa2002
2003-04-18 13:05:13 UTC
Advise on a HF Mini Mill z-axis conversion
ccq@x...
2003-04-18 14:26:34 UTC
Re: [CAD_CAM_EDM_DRO] Advise on a HF Mini Mill z-axis conversion
Hoyt McKagen
2003-04-18 17:21:26 UTC
Re: [CAD_CAM_EDM_DRO] Advise on a HF Mini Mill z-axis conversion
Harvey White
2003-04-18 21:37:03 UTC
Re: [CAD_CAM_EDM_DRO] Advise on a HF Mini Mill z-axis conversion