Re: [CAD_CAM_EDM_DRO] Advise on a HF Mini Mill z-axis conversion
Posted by
Harvey White
on 2003-04-18 21:37:03 UTC
On Fri, 18 Apr 2003 20:05:10 -0000, you wrote:
revolution...) is very coarse for the feed. Most people use 10
turns/inch or so.
Harvey
>I'm in the process of converting my Mini Mill into CNC and was1/2 inch pitch (if I read it right, a nut would move 1/2 inch for one
>hoping to tape your knowledge. Would a balll and lead screw Shaft
>that is 3/4" diameter, and pitch is 1/2" per turn be a good choice
>for the Z axis of the Mini Mill? If not, what ideally should I be
>looking for?
revolution...) is very coarse for the feed. Most people use 10
turns/inch or so.
Harvey
>
>Cheers,
>
>Shawn
>
Discussion Thread
shawnusa2002
2003-04-18 13:05:13 UTC
Advise on a HF Mini Mill z-axis conversion
ccq@x...
2003-04-18 14:26:34 UTC
Re: [CAD_CAM_EDM_DRO] Advise on a HF Mini Mill z-axis conversion
Hoyt McKagen
2003-04-18 17:21:26 UTC
Re: [CAD_CAM_EDM_DRO] Advise on a HF Mini Mill z-axis conversion
Harvey White
2003-04-18 21:37:03 UTC
Re: [CAD_CAM_EDM_DRO] Advise on a HF Mini Mill z-axis conversion