Re: [CAD_CAM_EDM_DRO] Re: g320 or g340 for mill setup?
Posted by
Jon Elson
on 2003-04-23 23:42:59 UTC
sparkness2001 wrote:
from them with a gecko. Of course, they will break things if you ever DO
supply peak input to it.
Well, given this info, your numbers may be right. But, you should not
be thinking
of maximum rapid feed. You should be concentrating on what linear force
at the table
you need to create. I designed for 1000 Lbs of force on the table for
my Bridgeport
retrofit.
Jon
>I picked up some motors off ebay that came off a bridgeport, rpm isAre these SEM motors? Those are AWESOME, but you can't get full output
>2500 no load, 5" dia . I have new ballscrews .200 lead
>
>
from them with a gecko. Of course, they will break things if you ever DO
supply peak input to it.
Well, given this info, your numbers may be right. But, you should not
be thinking
of maximum rapid feed. You should be concentrating on what linear force
at the table
you need to create. I designed for 1000 Lbs of force on the table for
my Bridgeport
retrofit.
Jon
Discussion Thread
sparkness2001
2003-04-23 09:54:55 UTC
g320 or g340 for mill setup?
Jon Elson
2003-04-23 10:19:41 UTC
Re: [CAD_CAM_EDM_DRO] g320 or g340 for mill setup?
sparkness2001
2003-04-23 10:56:15 UTC
Re: g320 or g340 for mill setup?
Jon Elson
2003-04-23 23:42:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: g320 or g340 for mill setup?