Re: [CAD_CAM_EDM_DRO] Questions on allegro uln5804 for my project......
Posted by
Harvey White
on 2003-04-24 19:37:35 UTC
On Thu, 24 Apr 2003 22:42:34 -0000, you wrote:
This is less than what your motor needs, unless you wish to run it at
1.25 amps (about half power). The large resistor in the common coil
lead to 20 volts limits the current. You will have to pick that value
for 1.25 amps steady state.
advances one step.
The clock input can be stopped in the 1 state, and the motor will hold
position.
Harvey
>I am going to use this to drive my stepper motor. My motor is ratedI think that this will handle 1.25 amps continuous, 1.5 amps surge.
>at 3.72 VDC and 2.5 AmpsDC and the chip is
>
>http://www.allegromicro.com/datafile/5804.pdf
>
>Which is rated at what seems like 1.5 Amps and (the part I am unsure
>about) 35 VDC. If it is really 35 VDC and 1.5 A then it is set, but
>if it is 1.5 A regardless of voltage, then ohhh well.....
This is less than what your motor needs, unless you wish to run it at
1.25 amps (about half power). The large resistor in the common coil
lead to 20 volts limits the current. You will have to pick that value
for 1.25 amps steady state.
>Each time the step input changes from high to low, the stepper
>Another question, I saw no input for a clock signal on the chip. I
>am assuming the step input would be oscillating since there is no
>dedicated clock input and one shot for a single step. Thanks for any
>help, Gabe.
advances one step.
The clock input can be stopped in the 1 state, and the motor will hold
position.
Harvey
>
Discussion Thread
gees_lude
2003-04-24 16:17:25 UTC
Questions on allegro uln5804 for my project......
Mariss Freimanis
2003-04-24 17:16:19 UTC
Re: Questions on allegro uln5804 for my project......
Harvey White
2003-04-24 19:37:35 UTC
Re: [CAD_CAM_EDM_DRO] Questions on allegro uln5804 for my project......
gees_lude
2003-04-24 21:45:28 UTC
Re: Questions on allegro uln5804 for my project......
Tony Jeffree
2003-04-24 21:55:41 UTC
Re: [CAD_CAM_EDM_DRO] Questions on allegro uln5804 for my project......