Re: moving table engraver

"andrewyslee" <andrewlee@s...> wrote:

> Simon Forrester <simon@v...> wrote:
>
> > 2. Just use 1/2 round bearing and let the weigth of the table hold
> > then down to the shafts, this will make alignment easier and

require

> > less bearing material.
>
> Any link to a picture of a 1/2 round bearing?

Tried to look for half round bearing on
http://www.mcmaster.com/
but got the message
No matches found for 'half round bearing'. ;-(

BTW McMaster Carr said they will ship anywhere in the world using
whatever carrier - USPS, UPS, DHL, etc. etc. and there is no minimum
quantity.

McMaster carry drill rods, but there are such a lot of matches for
the search for drill rods:

Precision Ground Drill rod
Air-hardening steel
Oil-hardening steel
Grade A-2
Grade D-2
Grade S-7
etc. etc.

In short, which one will be the most suitable for the purpose we have
in mind?