Re: [CAD_CAM_EDM_DRO] optical encoders
Posted by
Jon Elson
on 2003-05-23 10:22:43 UTC
george_barr wrote:
resolution motors?
Do you really think this will increase the resolution of the system?
Just because you
have X100 microstepping drives, do you think the motors can be
positioned in such
tiny fractions of a step? You can pretty much rely on getting half
steps, and probably
quarter steps, but friction interferes with getting much finer motion
than that.
I suspect you will end up with lots of hunting, but no real improvement in
actual positioning if you do this. If the current encoders are 200
cycle/rev, you
get 800 counts/rev if you count all transitions. I dislike pulses/rev
as it has an
imprecise meaning.
Jon
>I have stepper motors with 200 pulses per revolution (ppr) encodersWhat is the purpose of putting high resolution encoders on low
>on them. I would like to upgrade the disc on the encoders to get
>higher resolutions on them. Does anyone know how high of resolution
>or PPR I can go? How much are the discs? Any advice?
>
>
resolution motors?
Do you really think this will increase the resolution of the system?
Just because you
have X100 microstepping drives, do you think the motors can be
positioned in such
tiny fractions of a step? You can pretty much rely on getting half
steps, and probably
quarter steps, but friction interferes with getting much finer motion
than that.
I suspect you will end up with lots of hunting, but no real improvement in
actual positioning if you do this. If the current encoders are 200
cycle/rev, you
get 800 counts/rev if you count all transitions. I dislike pulses/rev
as it has an
imprecise meaning.
Jon
Discussion Thread
george_barr
2003-05-23 03:21:05 UTC
optical encoders
Miroslav Pejic
2003-05-23 05:08:55 UTC
RE: [CAD_CAM_EDM_DRO] optical encoders
Tim Goldstein
2003-05-23 07:58:15 UTC
RE: [CAD_CAM_EDM_DRO] optical encoders
Jon Elson
2003-05-23 10:22:43 UTC
Re: [CAD_CAM_EDM_DRO] optical encoders
george_barr
2003-05-23 15:13:59 UTC
Re: optical encoders
David A. Frantz
2003-05-23 16:16:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: optical encoders
John Craddock
2003-05-23 17:07:21 UTC
RE: [CAD_CAM_EDM_DRO] optical encoders
Miroslav Pejic
2003-05-26 05:18:01 UTC
RE: [CAD_CAM_EDM_DRO] optical encoders
Miroslav Pejic
2003-05-27 05:49:17 UTC
RE: [CAD_CAM_EDM_DRO] optical encoders