CAD CAM EDM DRO - Yahoo Group Archive

Re: Vertex Rotary Table Backlash (What is the best table for CNC)

on 2003-05-26 13:10:19 UTC
>--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Jeff" <rental@e...> wrote:
>
>
> Funny this subject came up. I have been looking at the Vertex to
> convert to cnc. Are there others out there that would be better? I
> haven't decided yet if I'm going to get a 4 or 6 inch. I looked at
> the 4" Sherline, a little more money but would be worth it if the
> backlash is less.
>
>
> Jeff Tice

I've converted a few Vertex now both the rotary tables and the
smaller dividing heads when I was doing some conversion work for Tony
Jeffree's DivisionMaster.
Some have been fine right out the box and others have benefitted from
a strip and a good clean and lighter lubricant applied.
The Verex does have a good system of adjustment and the cast iron
construction is a definite improvement as far as rigidity goes on the
alloy units.

John S.

John S.

Discussion Thread

fuddham 2003-05-25 19:10:19 UTC Vertex Rotary Table Backlash Jon Elson 2003-05-25 22:53:35 UTC Re: [CAD_CAM_EDM_DRO] Vertex Rotary Table Backlash Andrew Mawson 2003-05-26 03:02:42 UTC Re: Vertex Rotary Table Backlash Jeff 2003-05-26 05:12:52 UTC Re: Vertex Rotary Table Backlash (What is the best table for CNC) Tim Goldstein 2003-05-26 09:20:57 UTC RE: [CAD_CAM_EDM_DRO] Re: Vertex Rotary Table Backlash (What is the best table for CNC) bazer_20002000 2003-05-26 12:24:10 UTC Re: Vertex Rotary Table Backlash alex 2003-05-26 12:33:03 UTC Re: [CAD_CAM_EDM_DRO] Re: Vertex Rotary Table Backlash stevenson_engineers 2003-05-26 13:10:19 UTC Re: Vertex Rotary Table Backlash (What is the best table for CNC) stevenson_engineers 2003-05-26 13:19:31 UTC Re: Vertex Rotary Table Backlash alex 2003-05-26 13:53:11 UTC Re: [CAD_CAM_EDM_DRO] Re: Vertex Rotary Table Backlash stevenson_engineers 2003-05-26 14:18:52 UTC Re: Vertex Rotary Table Backlash alex 2003-05-26 14:27:15 UTC Re: [CAD_CAM_EDM_DRO] Re: Vertex Rotary Table Backlash