CAD CAM EDM DRO - Yahoo Group Archive

Re: Gecko 320s & Power Supply

Posted by vrsculptor
on 2003-05-30 07:52:09 UTC
> I have a power supply and three Gecko 320s in an enclosure ready to
connect motors and encoders. Is it safe to plug in power supply
without motors and encoders connected? I've triple and quadruple
checked my wiring.
>
Robert,
It is OK and often necessary to do this as long as you don't enable
the gecko's. Don't jumper reset (pin7?) to encoder +.

Roger S

Discussion Thread

res0clvs 2003-05-30 06:49:15 UTC Gecko 320s & Power Supply Brad Eyben 2003-05-30 06:51:36 UTC Re: [CAD_CAM_EDM_DRO] Gecko 320s & Power Supply vrsculptor 2003-05-30 07:52:09 UTC Re: Gecko 320s & Power Supply semenoff 2003-06-01 15:20:59 UTC Re: Gecko 320s & Power Supply