Questions about add-in parallel port card
Posted by
mrgamber
on 2003-06-03 08:02:21 UTC
I have an ITE887 add in card.
1. I have had my controller "blow" my motherboard twice. I added this
card in the hopes of blowing it up if I have a problem vs the
motherboard. Yes/No?
2. I can't get Mach1 to work with this as the address that it is at
0xA48 is not in Mach1's list. Mach2 works, but is still buggy. Can I
get Win2k to assign a different resource? I have looked on-line but
info in this card is non-existant.
Thanks,
Mike
1. I have had my controller "blow" my motherboard twice. I added this
card in the hopes of blowing it up if I have a problem vs the
motherboard. Yes/No?
2. I can't get Mach1 to work with this as the address that it is at
0xA48 is not in Mach1's list. Mach2 works, but is still buggy. Can I
get Win2k to assign a different resource? I have looked on-line but
info in this card is non-existant.
Thanks,
Mike
Discussion Thread
mrgamber
2003-06-03 08:02:21 UTC
Questions about add-in parallel port card
Jon Elson
2003-06-03 09:17:13 UTC
Re: [CAD_CAM_EDM_DRO] Questions about add-in parallel port card
turbulatordude
2003-06-03 09:33:06 UTC
Re: Questions about add-in parallel port card