Looking for feedback
Posted by
gravityflux
on 2003-07-07 08:13:31 UTC
Hey all,
I'm looking for feedback on a program I have written to aid in NC
programming. Basically it started out as a simple speed and feed
calculator with a small footprint and the ability to stay on top of
Bobcad (or whatever NC programming environment). I found it really
annoying to have to go hunting for it all the time!!
At any rate, it has evolved a bit and I have added circular milling
feed rate pro-rating as well as tapping feed calcs as drill point
length calculations. Really just all the basic stuff that you need
to know over and over again. Is anyone interested in checking out a
beta version? If so, send me a direct email.
Thanks,
-Cary
I'm looking for feedback on a program I have written to aid in NC
programming. Basically it started out as a simple speed and feed
calculator with a small footprint and the ability to stay on top of
Bobcad (or whatever NC programming environment). I found it really
annoying to have to go hunting for it all the time!!
At any rate, it has evolved a bit and I have added circular milling
feed rate pro-rating as well as tapping feed calcs as drill point
length calculations. Really just all the basic stuff that you need
to know over and over again. Is anyone interested in checking out a
beta version? If so, send me a direct email.
Thanks,
-Cary