EDM speeds - plans from Camtronics
Posted by
Mark
on 2003-07-17 06:35:37 UTC
I bought the wire EDM plans from Dan Mauch, and had some correspondence
with the author.
Using the power supply shown in the plans, cutting 1/8 inch material,
the author suggested cutting speeds of "hours per inch" (for Wire EDM,
not for sinker, just so that's clear...).
I thought I could make better use of my "spare" time... / mark
with the author.
Using the power supply shown in the plans, cutting 1/8 inch material,
the author suggested cutting speeds of "hours per inch" (for Wire EDM,
not for sinker, just so that's clear...).
I thought I could make better use of my "spare" time... / mark